Gigaset SX682 WiMAX User Manual page 29

If the scan was not successful:
ì
First check your access data by going back to the WiMAX configuration page (see
page 27).
ì
If you have entered your access data correctly, adjust the antenna.
If you are using the integrated antenna:
ì
Turn your Gigaset SX682 WiMAX by approx. 45°.
Correct:
Incorrect:
ì
Click Ok to restart the scan.
You must not move the Gigaset SX682 WiMAX during the scan. You
i
should therefore always place the Gigaset SX682 WiMAX upright and on
a level surface directly by the window.
If the scan has still not been successful with the alignment changed:
ì
Place the Gigaset SX682 WiMAX by a window that faces a different direction.
ì
If necessary, repeat the scan with all possible locations and alignments.
ì
If necessary, ask your provider for the location of the nearest WiMAX network base
station and select a location for your Gigaset SX682 WiMAX that points towards this
base station.
The best results will be obtained if the Gigaset SX682 WiMAX is in sight of a WiMAX net-
work base station.
If a line of sight is not possible, you can reflect the radio waves off neighbouring build-
ings. To do this, direct the Gigaset SX682 WiMAX at the building it is to reflecting off and
not at the WiMAX network base station.
Basic Setup Wizard
29