Table of Contents
Advertisement
19510300500_AUS
English, All Logos to be Ariston
Installation
Where to put your dryer
• Place your dryer at a distance from gas ranges,
GB
stoves, heaters, or cook tops because flames can
damage the appliance.
If you are going to install the appliance under a work
counter, be sure to leave a 10 mm space between the top
and any other objects on or above the machine and a 15
mm space between the sides and lateral furnishings or
walls. This is to ensure proper air circulation.
Ventilation
• When the dryer is in use, there has to be adequate
ventilation. Make sure you put your dryer in an
environment that is not damp and has proper air
circulation throughout. Airflow around the dryer is
essential to condense the water produced during the
washing, the dryer will not operate efficiently in an
enclosed space or cupboard.
! We do not recommend that the dryer is installed in a
cupboard because dangerous levels of heat can build up. !
The appliance must not be installed behind a lockable door,
a sliding door or a door with a hinge on the opposite side to
that of the tumble dryer in such a way that a full opening of
the tumble dryer door is restricted
! If using the dryer in a small or cold room some
condensation could be experienced
Water Drain
If your dryer is installed next to a drain the water can be
plumbed into this drain. This does away with the need to
empty the water container. If the dryer is stacked onto or
installed next to a washing machine it can share the same
drain.
The dryer is supplied with a length of hose and this
must be used to drain the condensed water under
certain conditions.
If you are using a washing machine with a spin speed
below 1100 rpm and drying loads of 7 kg or more also
for energy label tests to AUS/NZS 2442 you must plumb
out the water or the container may fill before the clothes
are dried. Follow the instruction below.
The height of the drain must be less than 3' (1 m) from the
bottom of the dryer.
Remove existing hose from position shown in picture A
And fit the supplied length of hose to location shown in
picture B.
! Make sure that the hose is not squashed or kinked
when the dryer is in its final location.
{PDF Created 18/01/13 22:28:00}
The length of the hose can be reduced if necessary to
avoid this.
Picture A
Electrical connection
Make sure of the following before you insert the plug into
the electrical socket:
• The socket must be grounded.
• The socket must be able to sustain the machine's
maximum power, which is indicated on the rating label
(see Dryer Description).
• Power voltage must be within the values indicated on
the rating label (see Dryer Description).
• The socket must be compatible with the dryer's plug.
Should this not be the case, replace the plug or the
socket.
! The dryer must not be installed outdoors, even if the
space is sheltered. It can be very dangerous if exposed to
rain or storms.
! Once installed, the dryer's electrical wire and plug must
be within reach.
! Do not use extension cords
! The power cord must not be bent or squashed.
! The power cord should be checked periodically and
replaced by a cord specially prepared for this dryer and
fitted only by authorised technicians. (see Service). New
or longer power cords are supplied at an extra charge by
authorised dealers.
! Ensure that any portable outlet or extension lead is
positioned so that it is not subjected to any splashing or
ingress of moistures
! The manufacturer denies any responsibility should any
of these rules not be followed.
! If in doubt about any of the above consult a
qualified electrician
Before you start using your dryer
Once you've installed your dryer and before you use it,
clean the inside of the drum to remove any dust that
could have accumulated during transportation.
4
TD4023FAUS Issue 1
Picture B
Hide quick links:
Advertisement
Table of Contents
