Changing The 3D Mode - Samsung LCD TV E-Manual

Changing the 3D Mode

MENU > Picture > 3D
11
Launch 3D and then select
21
Choose from the 3D modes that appear on the screen. The supported 3D Modes may vary
depending on the 3D content.
"
3D Mode is automatically configured for most 3D content.
The following 3D Modes are available. However, mode availability may vary depending on the 3D
content's format.
"
The supported resolutions vary for each mode. Refer to the "Supported Resolutions for 3D Modes" section
for more information.
●
(Off)
Of f Of f
Deactivates 3D viewing.
●
(Normal)
Converts normal images to 3D images.
"
Some formats do not support this mode.
●
(L/R)
Splits a single image into left and right overlapping images to create the 3D effect.
●
(T/B)
Splits a single image into top and bottom overlapping images to create the 3D effect.
●
(Horizontal Line)
Switches between left and right images one horizontal line at a time.
●
(Vertical Line)
Switches between left and right images one vertical line at a time.
●
(Pixel)
Switches between left and right images one pixel at a time.
●
(Frame)
Switches between left and right images one frame at a time.
When the TV is connected to a computer:
"
The (Horizontal Line),
computer's resolution is set to 1920x1800, or the computer is connected to the TV via an HDMI-DVI cable.
"
The (Frame) setting can only be selected when the computer's resolution is set to 1920x1080 and the
frequency to 60Hz.
> 3D Mode
Try Now
3D Mode
(Vertical Line), and
under Picture > 3D.
(Pixel) settings can only be selected when the