Connecting An Amplifier Or System Component - Panasonic Diga DMR-ES10EB Operating Instructions Manual

1
STEP Connection

Connecting an amplifier or system component

■ To enjoy multi-channel surround sound on
DVD-Video
Connect an amplifier with Dolby Digital, DTS and MPEG decoders
using an optical digital audio cable and change the settings in
"Digital Audio Output" (➔ page 35).
•
Digital output is not digital with DVD-Audio (figure 1), however you
can enjoy it in analogue (figure 2).
(For digital playback, set "DVD-Audio Video mode Playback"
(➔ page 35) to "On" when the DVD-Audio contains DVD-Video.)
•
You cannot use DTS Digital Surround decoders not suited to DVD.
Optical digital audio cable
Do not bend this cable sharply.
Insert fully, with this side facing up.
RQT8016
10
Amplifier's rear panel
OPTICAL IN
This unit's rear panel
(figure 1)
■ Connection to a stereo amplifier
White
Red
This unit's rear panel
(figure 2)
Do not place the unit on
amplifiers or equipment
that may become hot.
The heat can damage the unit.
Amplifier's rear panel
AUDIO IN
R L
Red White
Audio cable