Connecting A Handset Or Headset - Mitel 6869i Installation Manual

Installation and Setup

Connecting a Handset or Headset

Handset
Turn the phone over and locate the handset jack marked j. Insert one end of handset cord into the jack until it
clicks into place. Then route the handset cord through the groove as shown in the illustration below. Attach the hand-
set to the other end of the handset cord.
Headset (Optional)
Turn the phone over and locate the headset jack marked
insert the headset cord into the jack until it clicks into place. Then route the headset cord through the groove as shown
in the above illustration.
If you have a DHSG/EHS headset with an RJ45 6-pin or 8-pin connector, remove the plastic headset jack adapter and then
insert the cord into the jack until it clicks into place.
Alert!
The headset port is for headset use only. Plugging any other devices into this port may cause damage to the phone and
will void your warranty.
7
To Handset
f
. If you have a headset with an RJ9/RJ22 4-pin connector,
Pull to remove headset jack adaptor
41-001553-00 REV00 – 10.2014