Canon Image runner 5075 Easy Operation Manual page 36

Additional Functions
TX Settings
TX Terminal ID
See the Sending and Facsimile Guide Chapter 9
Enables you to specify whether the Terminal ID information is printed at the top of documents
that you send through fax/I-fax.
Use Chunked Encoding with WebDAV Sending
See the Sending and Facsimile Guide Chapter 9
Enables you to set whether to send data in chunks of a known length when sending a fi le of
(4/4) unknown size with WebDAV. If this mode is used, transmission time is reduced, as it is not
necessary to calculated the fi le size before sending it.
Confirm when Sending 2-Sided Orig. with Stamp
See the Sending and Facsimile Guide Chapter 9
This mode enables you to set whether to display a confi rmation screen when stamping a
two-sided original that is to be sent (only if [2-Sided Single Pass] is set for the feeder scan
type).
Initialize TX Settings
See the Sending and Facsimile Guide Chapter 9
Enables you to restore all of the Send Settings to their defaults (initial settings).
*11 Displayed only if the optional Universal Send Kit is activated.
Common Settings: RX Settings
2-Sided Print (see p. 77)
See the Sending and Facsimile Guide Chapter 9
Enables you to print received documents on both sides of the paper you select. This enables
you to save paper.
Select Drawer
See the Sending and Facsimile Guide Chapter 9
Enables you to set how the machine prints documents when there is no paper matching the
size of the received document.
RX Settings
Receive Reduction
See the Sending and Facsimile Guide Chapter 9
Enables you to set the machine to automatically reduce received documents so that the
whole document is printed within the printable area of the paper.
Received Page Footer
See the Sending and Facsimile Guide Chapter 9
Enables you to set whether the machine prints the date received, day received, time
received, transaction number, and page number at the bottom of the received document.
(1/1)
2 On 1 Log
See the Sending and Facsimile Guide Chapter 9
Enables you to print two received documents of the same paper size onto a single sheet of
paper.
69
Fax Settings: User Settings
Unit Telephone #
See the Sending and Facsimile Guide Chapter 1
Enables you to store the machine's fax number. The number may also be displayed on the
touch panel display of the receiving party's machine, depending on their type of machine.
Tel Line Type
See the Sending and Facsimile Guide Chapter 1
Enables you to set the telephone line type.
User Settings
Volume Control
Sending and Facsimile Guide Chapter 9
Enables you to set the volume for the alarm and monitor tones that the machine emits during
a fax transmission.
*7 Displayed only if the optional Super G3 FAX Board is installed.
(1/1)
Fax Settings: TX Settings
ECM TX
See the Sending and Facsimile Guide Chapter 9
Enables you to reduce the effect of system and line errors on documents that occur during
sending or receiving with another fax unit that supports ECM.
Pause Time
See the Sending and Facsimile Guide Chapter 9
Enables you to set the pause time when sending a fax.
TX Settings
Auto Redial
See the Sending and Facsimile Guide Chapter 9
Enables you to set the machine to automatically dial the recipient's fax number again if
the recipient cannot be dialed due to a busy line, or if a sending error occurs.
Check Dial Tone Before Sending
See the Sending an Facsimile Guide Chapter 9
Enables you to set whether to check for a dial tone before sending a fax.
(1/1)
*7 Displayed only if the optional Super G3 FAX Board is installed.
Additional Functions
70