Attaching The Connecting Rod; Adjustment Of The Pedal - JUKI LZ-2290A Instruction Manual

How to lock the cord clamp
4 Lightly press the corner of clamp.
(Cord clamp is locked with a click.)
2
C
1
B

4-9. Attaching the connecting rod

2
1
B

4-10. Adjustment of the pedal

1
3
4
4
3
Clamp
3
A
2
4
When the insertion of the connector is completed, lock
the cord clamps.
q Take care so that the cord is not caught between
the rear cover and the electrical box main body,
close the rear cover while pressing section A on
the lower side of the rear cover, and tighten four
screws 1.
w Press down cord presser plate C of cord through
hole B of the front cover, press the cord, and tighten
screws 2.
1) Fix connecting rod 1 to installing hole B of pedal
lever 2 with nut 3.
2) Installing connecting rod 1 to installing hole A will
lengthen the pedal depressing stroke, and the pedal
operation at a medium speed will be easier.
Installing the connecting rod
1) Move pedal 3 to the right or left as illustrated by
the arrows so that motor control lever 1 and
connecting rod 2 are straightened.
Adjusting the pedal angle
1) The pedal tilt can be freely adjusted by changing
the length of the connecting rod.
2) Loosen adjust screw 4, and adjust the length of
connecting rod 2.
11