RX-Z1/DSP-AZ1
Then the screen returns to the one shown above. Click
on the "EXIT" button to complete the writing software.
Check that the writing software window has closed and
then disconnect the plug.
If the plug is disconnected first, an error will occur
when ending the writing software. Make sure that
writing the software is over before disconnecting the
plug.
If a communication error has occurred due to poor
connection of faulty power supply, an error dialog as
shown below may appear.
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
In any case, disconnect the plug, finish the writer
software of the PC by clicking the close box or by
another method and start all over again.
The dialog (Set baud rate) in the last screen above, is
not necessarily an error screen but it appears for
adjusting the baud rate when an error has occurred.
Ignore it and click on the close box.
183