Yamaha RX-Z1 Service Manual page 21

Starting DSP IF STATUS menu
Enter the DSP IF STATUS menu by pressing the INPUT
MODE key of the main unit.
[RX-Z1]
Starting DSP IF SUB-MENU
selection
STATUS
[RAV2000Z1]
DIAG menu selection
PARAMETER
LEVEL
TEST
SLEEP
SUB-MENU selection
• Functions in DIAG mode
In addition to the DIAG menu items, functions as listed
below are available.
• Input selection (including ZONE2), 6CH input
• REC OUT switching
• ZONE2 input, volume
• Front/Center/Rear/Sub-woofer level adjustment
• Muting
• Speaker relay A/B
• Power on/off
• Master volume
* Functions related to the tuner and the set menu are not
available.
* It is possible to confirm DSP IF STATUS Menu while
keeping the signal process (operation status) of each
DIAG menu by using the input mode key of the main
unit.
• Initial settings used to start DIAG
The following initial settings are used when starting DIAG.
When DIAG is canceled, these settings are restored to
those before starting DIAG.
• Master volume: -40dB
• Input, ZONE2 Input: DVD (6CH INPUT OFF)
• ZONE2 volume: -6dB
• Front/Center/Rear/Sub-woofer level: 0dB
• Audio mute: OFF
• Speaker relay A/B: ON
DIAG menu Starting DSP IF STATUS
selection
[DSP-AZ1]
SUB-MENU selection DIAG menu selection
[RAV225]
DIAG menu selection
SUB-MENU selection
RX-Z1/DSP-AZ1
20