Sanyo HVR-DX625 Instruction Manual page 48

DF-Q77E2D-HR-O
• The Timer indicator lights on the front panel display when the DVD Recorder+VCR is ready for the Timer
• The DVD Recorder+VCR will automatically power off when the Timer Recording ends.
• There is a short delay when a timer recording finishes to confirm the recorded program. If two timer recordings
Timer Recording using G-Code system
Thanks to this programming system, you no longer need to tediously enter the date, programme number, start
and end time. All the information needed by the DVD Recorder+VCR for programming is contained in the G-Code
programming number. This G-Code number is found in most TV listings.
1
Insert recordable media such as DVD±R ,DVD±RW, recordable VHS tape.
2
Press [TIMER].
Press [SETUP] and select 'Timer REC'. Then press [ENTER].
or
The 'Timer Recording' menu appears.
3
Select 'G-Code' with [ ... / † ] and confirm with [ENTER].
The 'G-Code' menu appears.
Enter the entire 'G-Code' number. This number is up to 9 digits long and
can be found next to the start time of the TV programme in your TV listings
magazine.
e.g.: 5-234-89 or 5 234 89
Enter 523489 for the 'G-Code' number.
4
Press [ENTER] to confirm.
5
The decoded information appears after confirmation. You can change the
information by selecting the appropriate input field using [...†]. If
required, change the information using [...†].
If all the information is correct, press the [ENTER] button. The programming
information is stored in a TIMER block.
6
Press [SETUP] to exit the Timer Record List.
7
Timer indicator will light or blink. You must power off the DVD Recorder+VCR
to start the Timer Recording.
• G-Code is not available in some countries.
• G-Code is a trademark applied for by Gemstar Development Corp. The
42
Downloaded From Disc-Player.com Daewoo Manuals
2006.6.21 3:57 PM ˘ ` 42
Recording.
are set to record sequentially (one right after the other), the very beginning of the later program may not be
recorded.
G-Code system is manufactured under license from Gemstar
Development Corporation.
mac001 1200DPI 90LPI
Move
...†
Confirm
ENTER
Timer Recording
Code
Media
Mode
Repeat
Input Digits
0-9
SETUP Exit timer rec
Timer Recording
PR No
...
PR 1
†
Media
DVD
Input Digits
0-9
TIMER Exit timer rec
Timer Recording
PR No Date
PR01 16/1
Delete
§
Prev Page
Timer Recording
Timer Recording
Manual
G-Code
01/01 00:13:23
1111
DVD
SP
Once
Confirm and Exit
ENTER
01/01 00:13:23
Date Start Stop Repeat
16 / 1 11 : 00 12 : 00 Once
Sun
Title Mode
TITLE PR 4 SP
Delete
01/01 00:13:23
Start Stop Media Repeat Mode
11:02 12:00 DVD Once SP
New Input
Edit Exit
ENTER TIMER
∞
Next Page