Advertisement
CAUSE:
1) Power not reaching main switch.
2) Defective power cord.
3) Faulty switches or wiring.
4) Blown fuse or tripped circuit breaker.
5) Problem with brushes, field windings, or arma-
tures. (vacuum or brush motor)
6) Reset switch on back.
CAUSE:
1) Vacuum head blocked.
2) Hose blocked.
3) Recovery tank not sealed properly.
CAUSE:
1) Belt broken.
2) Brush jammed.
3) Brush pulley broken.
CAUSE:
1) Jet blocked.
2) Solution filter blocked.
TROUBLESHOOTING
MOTORS NOT RUNNING
LOSS OF VACUUM SUCTION
BRUSH NOT FUNCTIONING PROPERLY
SPRAY JET NOT FUNCTIONING PROPERLY
SOLUTION:
1) Check power supply. Check fuses/circuit
breaker. Contact service center.
2) Contact manufacturer or service center.
3) Contact manufacturer or service center.
4) Reset circuit breaker according to operating
instructions or replace fuse if qualified.
5) Repair or replace defective part.
6) Push reset switch.
SOLUTION:
1) Visually inspect and clear blockage.
2) Visually inspect and clear blockage.
3) Check tank for damage or adjust
for proper fit.
SOLUTION:
1) Replace belt.
2) Visually inspect and clear blockage.
3) Replace pulley.
SOLUTION:
1) Visually inspect and clean according to
operating instructions.
2) Visually inspect and clean according to
operating instructions.
7
Advertisement
