Page 1
Sanitaire ® 3 GALLON Self Contained Extractor SC6092A Part No. SC6092A Rev 1 (8/13) Owner’s Guide IMPORTANT Do not return this product to the store. Call 1-800-800-8975* Monday - Friday 8:00 AM to 7:30 PM and Saturday 10 AM to 6:30 PM Central time or visit our web site, www.sanitairevac.com for any of the...
Please safeguard the original receipt / invoice. If you experience any problems with your unit during the warranty period, the original receipt / invoice will act as proof of purchase. Contact Sanitaire for any warranty inquiries. Do not return a failed unit to the place of purchase or service center. Any charges for the shipping of a Sanitaire unit under warranty are purchaser’s responsibility unless Sanitaire requests such return in writing.
Use this unit only as described in this manual. Use only manufacturer’s recommended attachments. To reduce the risk of personal injury or damage to your unit use only Sanitaire recommended accessories When using an electrical appliance, basic precautions should always be followed including the...
EXTENSION CORDS When using an extension cord with your unit, refer to the following table to determine the required A.W.G. wire size. Before using the cleaner make sure the power cord and extension cord are in good working condition. Make repairs or replacements before using the vacuum cleaner. Only use extension cords that are rated for outdoor use.
Page 5
PRE-OPERATION INSTRUCTIONS NOTE - FOR COLOR FASTNESS: Before using carpet cleaning chemicals, test on an inconspicuous part of the carpet for color fastness. Place the solution on a small piece of clean white cloth or tissue. Rub the car- pet area vigorously with the cleaning chemical. Exces- sive amounts of dye showing on the material would indicate that the colors are not colorfast, and should not be wet cleaned.
GENERAL INSTRUCTIONS STORAGE WHEN CLEANING IS FINISHED: 1) Disconnect the SOLUTION HOSE on the front of the machine by pushing in on the ring of the solution fitting. 2) Connect the drain hose (clipped to the back) to the SOLUTION HOSE fitting and place the other end into the RECOVERY TANK. Press the SOLUTION switch to the “on”...
TROUBLESHOOTING MOTORS NOT RUNNING CAUSE: SOLUTION: 1) Power not reaching main switch. 1) Check power supply. Check fuses/circuit 2) Defective power cord. breaker. Contact service center. 3) Faulty switches or wiring. 2) Contact manufacturer or service center. 4) Blown fuse or tripped circuit breaker. 3) Contact manufacturer or service center.