Scytek electronic G5.2W SERIES Product Manual page 11

Automatic Cold Start Temperature Setting ( 2 step procedure, for second step see page 7 under "C st" )
The Automatic Cold Start setting sets the temperature threshold. If automatic start is set to cold temperature setting,the
starter will activate every 2 or 4 hours if the temperature drops bellow the set value. (LED will flash slow in this mode)
1. Press and hold Buttons 2 and 3 until the remote beeps five times.
· "cold" is shown indicating automatic cold start temperature set mode is entered.
2. Press Button 2 to increase the temerature.
3. Press Button 3 to decrease the temperature.
4. When the desired temperature is displayed, press Button 1 to store the value.
· The remote will display the temperature and beep 3 times then 4 times to indicate the set temperature.
Automatic Hot Start Temperature Setting ( 2 step procedure, for second step see page 7 under "H st" )
The Automatic Hot Start setting sets the temperature threshold. If automatic start is set to hot temperature setting, the
starter will activate every 2 or 4 hours if the temperature rises above the set value. ( LED will flash slow in this mode)
1. Press and hold Buttons 2 and 3 until the remote beeps six times.
· "hot" is shown indicating automatic hot start temperature set mode is entered.
2. Press Button 2 to increase the temerature.
3. Press Button 3 to decrease the temperature.
4. When the desired temperature is displayed, press Button 1 to store the value.
· The remote will display the set temperature and beep 3 times then 4 times to indicate the set temperature.
Power Save Mode
Power save mode disables automatic pager operations, alarm and starter status must be checked manually using button
5 for confirmation.
1. Press and hold Buttons 2 and 3 until the remote beeps six times.
· "PS" is shown indicating Power Save set/reset mode is entered.
2. Press Button 1 to tougle Power Save On/Off.
· The remote will display On or Off indicating the current status of the pager.
Pager power save mode status is indicated bellow
Normal
Mode
LCD Backlight
Transmitter Button 5 is used for confirmation, transmitter programming, as well as activation of the LCD
backlighting for use in the dark. Press and release button 5 momentarily to activate the LCD backlight.
System Confirmation
The 2-way transmitter's confirmation feature allows the current vehicle status to be displayed at any time.
To display system status:
1. Press and hold Button 5 until the display shows CON.
· The transmitter will beep once.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will display the current system status.
Programmable Functions using the LCD Transmitter
Pressing and holding transmitter button 5 will scroll through several transmitter programmable options -
DEG, AUTO, SPCL, SSCL, C St, H St, A St, Snd .
DEG Check the temperature inside the vehicle
1. Press and hold Button 5 until the display shows DEG
·The transmitter will beep twice.
2. Release Button 5.
· The transmitter will beep four times.
· The LCD panel will display the temperature inside the vehicle
Power Save
Mode
G5.2W, G2.2W, A4.2W, A1.2W - Page 7