Table of Contents
Advertisement
Available languages
Available languages
2
Figure 5
Page -22 -
1
2
HOW TO OPERATE THE MACHINE
How To Start/Stop The Machine
WARNING:
Never start a polisher when
the handle is in the vertical
position.
The following step applies to the C2K-1600DS and C2K-
2000DS only:Select high or low speed with the switch
located on the motor cover. Moving the switch lever up
selects high speed. Moving the switch lever down
selects low speed.
The following steps apply to all C2K series:
The switch to start and stop the machine is activated
by the interlock switch (1) and the levers (2) under the
handle grips. See figure 5.
To start the machine, follow this procedure:
1. Lower the handle
2. Lock the handle in the best position for operation.
NOTE: Make sure you hold the handle with both
hands.
3. Push the interlock switch (1), and apply pressure to
the levers (2). See figure 5.
How To Control The Machine
NOTE: Make sure you hold the handle with both
hands.
The side to side movement of the machine is controlled
by raising the handle and pressing down on the handle.
To move the machine to the left, press down on the
handle slightly. To move the machine to the right, raise
the handle slightly.
MAINTENANCE
WARNING: Maintenance must be done
by authorized personnel
only.
Maintenance Instructions
Return the machine to a Clarke Authorized Service
Location every 12 months for maintenance inspections.
®
Clarke
Operator's
Manual- C2K Series 120V
Advertisement
Table of Contents
