Bernette London 7 Instruction Manual page 73

72 Special Functions
Memory Editing functions -
Change a stored stitch or its parameters
Precondition: with existing patterns in Memory
Press the memory button to enter the Memory
Review/Edit Mode, the screen shows the
1st memory position
stitch of the 1st memory position.
2nd memory position
Use selector wheel to select the stitch that
should be replaced or its parameters changed.
To change the stitch press the pattern group
selection button, the stitch number starts
flashing.
To change its parameters press the stitch
length, stitch width or function button.
2nd memory position
Use selector wheel to select new value.
(E.g. stitch 47)
Before pressing set/disp button:
- The parameters of the selected stitch, such
as stitch length and stitch width, mirroring
and twin needle, may be adjusted by
pressing the corresponding button.
- The stitch can be test sewn by pressing
the start/stop button or the foot controller.
Note, that the machine will automatically
stop sewing at the end of the stitch.
2nd memory position
Press set/disp button to store and return to
Memory Review/Edit Mode.
Example:
Stitches in Memory before replacing a stitch:
stitch no.
mem pos.
Stitches in Memory after replacing stitch no. 26:
Stitch no.
mem pos.
Please note:
25 26 15 01 30 48
01 02 03 04 05 06
25 47 15 01 30 48
01 02 03 04 05 06