Kickplate Installation; Door Stop Adjustment; Hinge Adjustment - Viking Range VCBB363 Installation Instructions Manual

KICKPLATE INSTALLATION

Align the holes on both ends of the louvered panel
with the holes in the base of the unit.
Adjust the kickplate to the desired height and fasten
in place by tightening the screws in the slot. Attach
the kickplate to the unit on each side with the two
black phillips head screws provided.

DOOR STOP ADJUSTMENT

1. Remove center grille louver from the top air grille
assembly.
2. Remove top air grille by removing (2) 1/4" screws with an
8" (20.3 cm) long magnetic 1/4" (.6 cm) nut driver. Pull
assembly forward.
3. Open refrigerator door so door stop arm and shoulder
screw are accessible. Shoulder screws should be in 110
door opening position.
4. Remove shoulder screw and place shoulder screw in the
90 o or 120 o door opening position.
5. Replace top air grille assembly.

HINGE ADJUSTMENT

Verify proper door alignment. Only the top hinge is adjustable.
1. Remove the center grille louver from the top air grille
assembly.
2. Remove top air grille by removing (2) 1/4" screws with an 8"
(20.3 cm) long magnetic 1/4" (.6 cm) nut driver. Pull
assembly forward.
3. Loosen the (4) top hinge screws.
4. Align refrigerator door by lifting.
5. Tighten screws.
6. Replace top air grille assembly
adjustments (on
both ends)
o
34
Slots for
Attach to unit with
screws
(on both ends)