Performance Checklist - Viking Range VERT301-4B Installation Manual

PERFORMANCE CHECKLIST

The installer should carry out the following performance checks. Refer to instructions below.
1. Check top surface elements - glow red when turned on.
2. Check hot surface indicator lights - glow red when corresponding element is on.
3. Check oven bake function - bake element on full power.
Convection bake function - bake element is same with the convection fan on.
4. Check convection cook function - convection cook element (behind fan cover) on and convection fan on.
5. Check mini broil function - center broil element on.
6. Check maxi broil function - center and outside broil elements on. Convection broil function is the same as maxi
broil with the convection fan on.
7. Check self-clean function - door will lock and in approximately 30 seconds; the center and outside broil elements
will turn on. Check broil elements through window to make sure they are on, then abort self-clean cycle to unlock
door.
CAUTION: Do not run self-clean cycle for more than 10 minutes with oven racks and rack supports inside oven.
This could cause them to discolor due to the high temperature required for self-cleaning.
FINAL PREPARATION
1. Some stainless steel parts may have a plastic protective wrap which must be removed. The interior of the oven
should be washed thoroughly with hot, soapy water to remove film residues and any installation dust or debris
before being used for food preparation, then rinsed and wiped dry. Solutions stronger than soap and water are
rarely needed.
2. All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner designed for this
material. If buildup occurs, do not use steel wool, abrasive cloths, cleaners, or powders! If it is necessary to scrape
stainless steel to remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wood or
nylon scraper. Do not use a metal knife, spatula, or any other metal tool to scrape stainless steel! Scratches are
almost impossible to remove.
Any adjustments necessary that are a result of the installer not following instructions will be the responsibility of the
installer, dealer, or the end user of the product.
REPLACEMENT PARTS
Only authorized replacement parts may be used in performing service on the range. Do not repair or replace any part
of the appliance unless specifically recommended in the manual. All other servicing should be referred to a qualified
technician.
14 15