Step 7: Secure The Drive - HP StorageWorks Ultrium 232i Getting Started Manual

Step 7: Secure the drive

Note The server latches and side views of your server model may not be exactly the same as shown
in the illustrations. Please refer also to you server documentation.
Mounting hardware used (HP ProLiant)
Ensure that you use the correct mounting rails or locating screws, as described in "Step 4:
Attach mounting hardware" on page 15. The server also incorporates a locking mechanism
to hold the tape drive in place.
1
Push the server latch down to lock the tape drive into position, as shown in Figure 8a.
2
Ensure blanking plates are in place over empty bays and replace the cover on the server.
No mounting hardware used (HP AlphaServer)
1
Use the M3 screws provided with the tape drive in the screw pack labeled 'General Mounting
Screws'. Check that the holes in the chassis are aligned with the holes in the sides of the drive
and use a regular Phillips screwdriver to secure the M3 screws, as shown in Figure 8b.
If you cannot tighten the screws, use the washers provided in the pack.
2
Ensure blanking plates are in place over empty bays and replace the cover on the server.
21