Provision The Vm-Series Firewall - PaloAlto Networks VM-100 Deployment Manual

Vm-series firewall deployment guide
Table of Contents

Advertisement

Set Up a VM-Series Firewall on the Citrix SDX Server

Provision the VM-Series Firewall

Provision the VM-Series Firewall on the SDX Server
Step 1
Access the SDX server.
Step 2
Create the VM-Series firewall.
Note
Allocate the total number of data
interfaces that you might require on the
VM-Series firewall during initial
deployment. Adding or removing
interfaces to the VM-Series firewall after
initial deployment will cause the data
interfaces (Eth 1/1 and Eth 1/2) on the
VM-Series firewall to re-map to the
adapters on the SDX server. Each data
interface sequentially maps to the adapter
with the lowest numerical value, and can
therefore cause a configuration mismatch
on the firewall.
Continue with
Activate the
VM-Series
Deployment
Guide
Launch the web browser and connect to the SDX server.
1.
2.
3.
4.
5.
6.
Note
Note
7.
License.
Select
Configuration > Palo Alto VM-Series > Instances
Click
.
Add
Enter a name for the VM-Series firewall.
Select the .xva image that you uploaded earlier. This image is
required to provision the firewall.
Allocate the memory, additional disk space, and the virtual
CPUs for the VM-Series firewall. To verify resource allocation
recommendations, see Requirements.
Select the network interfaces.
a.
Use the management interfaces 0/1 or 0/2 and assign an IP
address, netmask, and gateway IP address.
If needed, you can use a data interface on the SDX server
for managing the firewall.
b.
Select the data interfaces that will be used for handling traffic
to and from the firewall.
If you plan to deploy the interfaces as Layer 2 or virtual wire
interfaces, select the
Allow L2 Mode
firewall can receive and forward packets for MAC addresses
other than its own MAC address.
Review the summary and click
process. It takes 5-8 minutes to provision the firewall. When
completed, use the management IP address to launch the web
interface of the firewall.
Install the VM-Series Firewall
.
option so that the
to begin the installation
Finish
29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vm-200Vm-1000-hvVm-300

Table of Contents