Audio Upload; Focus Tab - Adjusting The Focus (Snc-Ch240/Ch135/Ch140 Only); Focus/Zoom Tab - Adjusting The Focus/Zoom (Snc-Ch180/Ch280/Dh140/Dh180/Dh240/ Dh280 Only) - Sony Ipela SNC-CH135 User Manual

Codec
Select the bit rate of audio from the m microphone input
connector. G.711 (64kbps), G.726 (40kbps), G.726
(32kbps), G.726 (24kbps) or G.726 (16kbps) can be
selected.
Note
No audio is output if JPEG or JPEG/Flash is used for the
Plug-in free viewer.
Echo canceler
Select On to reduce echo from audio transmission.
Ambient noise filter
Select On to activate the Ambient noise filter.
Dynamic range compressor
Select On to activate the Dynamic range compressor.

Audio upload

Using SNC audio upload tool stored in the supplied
CD-ROM, you can output audio that is input to the
computer's audio input terminal from a powered speaker
connected to the line output jack of the camera.
Select On to output audio from the speaker.
Volume
Set the speaker volume level from – 10 to + 10.
OK/Cancel
See "Buttons common to every menu" on page 33.
Focus tab — Adjusting the Focus
(SNC-CH240/CH135/CH140 only)
Adjust the focus by moving the flange back position of
the imaging device.
42
Setting the Camera Image and Audio — Camera Menu
Preview screen
Preview the image and adjust the focus.
The current image focus position is superimposed when
adjusting the focus.
For the details on each button, refer to the Control bar of
the Plug-in free viewer (page 24).
Note
If you click the buttons in this tab, in order to adjust the
focus easily, the settings below are temporarily changed:
– Privacy masking and Cropping are deactivated.
– The current image focus position is superimposed.
– The alarm of Motion detection is deactivated.
– View-DR is turned on.
Adjusting the focus
Click Start button in Easy Focus to set the focus to the
optimum position.
Note
The most suitable focus position may not be available
depending on imaging conditions.
If so, click the –20, –5, –1, +1, +5 or +20 buttons to
adjust the focus accordingly.
Focus reset
Click the Reset button to return to the default flange
back position.
Focus/Zoom tab — Adjusting the
focus/zoom (SNC-CH180/CH280/
DH140/DH180/DH240/DH280 only)
Adjust the focus and zoom position by looking at the
image.
Preview screen
Preview the image and adjust the focus/zoom.
The current image focus position is superimposed when
adjusting the focus/zoom.
For the details of each button, please refer to the Control
bar of the Plug-in free viewer (page 24).