When you are using Windows Vista, pop-up “Auto
Play” may appear. For details, “Installing software”
in “When using Windows Vista” on page 11.
2
Click the Setup icon of SNC audio upload tool.
The “File Download” dialog opens.
When you are using Windows XP Service Pack 2 or
later, or Windows Vista, a message regarding the
active contents may appear. For details, see
“Installing software” in “When using Windows XP
Service Pack 2 or later” on page 9 or “Installing
software” in “When using Windows Vista” on
page 11.
3
Click Open.
Note
If you click “Save this program to disk” on the “File
Download” dialog, you cannot install the tool
correctly. Delete the downloaded file, and click the
Setup icon again.
4
Install the SNC audio upload tool following the
wizard displayed.
If the Software License Agreement is displayed,
read it carefully and accept the agreement to
continue with the installation.
Connecting the Camera to the
Computer
1
Connect a speaker to the 5 (line output) jack on the
camera.
2
Connect a microphone to the microphone input jack
on the computer.
Note
If the microphone input jack of the computer is not set
correctly, no sound is transmitted from the computer and
nothing is output from the speaker connected to the
camera.
Set the microphone input jack from the control panel of
Windows.
On Windows XP
1
Select Sounds and Audio Device from Control
Panel.
2
Click Volume in the Sound Recording section on
the Audio tab.
The Recording Control window opens.
3
Check Select in the Microphone section.
Page 117