Table of Contents
Advertisement
Chapter 1 Installing OS
4. On the left pane of the RDR Utility, right click on the Slot 1 disk of PCI Module 10 and select Create
RDR Virtual Disk.
5. Click Yes.
6. Click OK.
7. Insert the disk to set dual configuration into the slot 1 of PCI module 11, and perform the Step 2.
If a hard disk drive is already mounted, this procedure is not necessary. Perform the Step 2 only.
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows Server 2008)
Depending on the disk condition, RDR setting may take some time and RDR Utility may
Tips
pause for a few minutes. There is no error, so wait until the process is completed.
Important
If RDR is specified to a disk which contains the system partition or partition which
cannot be unmounted, the system restart pop-up message appears. If you click Yes,
the system is restarted in two minutes automatically. Go on to Step 8. when the
system is restarted.
For a disk to be inserted, use a new or physically formatted disk which has the same
Important
capacity as the synchronization source. If such a disk is not used, disks are not
duplicated successfully.
As for physical format, refer to Chapter 3 (2. SAS Configuration Utility) in
Maintenance Guide.
3. Setting Up Windows Server 2008 R2
87
Advertisement
Table of Contents
