Subscribe to Our Youtube Channel
Related Manuals for eZip 500DD Series
Summary of Contents for eZip 500DD Series
- Page 2 ® ® Currie Technologies Currie Technologies TAbLE Of CONTENTS Section 1 ..Technical Information ....page 3 Section 2 ..Safety Guidelines ....page 4-7 Section 3 .
- Page 3 ® ® Currie Technologies Currie Technologies Section 2 - SAfETY GUIDELINES WARNING Never operate this product without proper training or LIMITATIONS Of SAfETY AND WARNING NOTICES instructions. WARNING This owner’s manual includes important safety WARNING Children under 13 years old should never operate these guidelines and maintenance instructions.
- Page 4 ® ® Currie Technologies Currie Technologies Avoid excessive speed associated with downhill riding. Always drive slowly can repaired or replaced. and pay extra attention when operating on unfamiliar terrain. Always be alert to changing terrain conditions when operating this product. Never operate on The charger is not a toy and should be kept out of reach children at all times.
- Page 5 ® ® Currie Technologies Currie Technologies STOPPING from the scooter. To slow down or come to a stop, allow the throttle to completely return to its Install the front wheel (certain models will have the front wheel “zero speed” position already installed) being sure to properly install the safety washers.
- Page 6 ® ® Currie Technologies Currie Technologies Open the stem hinge to Section 4 - REPAIR & MAINTENANCE access the steerer bolt (6mm Allen Bolt or 13mm IMPORTANT: Some adult assembly required. Hex Bolt). HANDLEbAR ASSEMbLY AND ADjUSTMENT Electro-Drive™ scooters are equipped with an folding stem hinge. Take care not to pinch your hands or fingers in the hinge when you are folding and locking the handlebar in place.
- Page 7 ® ® Currie Technologies Currie Technologies Rotate the stem QR lever Align the handlebars to the forward into of the upper front wheel. The handlebars plate (Ref Photo A). Close must be perpendicular to the the stem QR lever (Ref front wheel.
- Page 8 ® ® Currie Technologies Currie Technologies qR LEvER ADjUSTMENT: bATTERY PACk, CHARGER PORT AND CHARGER If the quick release lever is either ELECTRO-DRIvE™ SMART CHARGER: The Electro-Drive™ scooter comes too tight (cannot be flipped to its fully with its own Electro-Drive™ Smart Charger that connects with an easy- locked position) or is too loose (can access charger port for recharging the batteries.
-
Page 9: Battery Care And Maintenance
® ® Currie Technologies Currie Technologies bATTERY CARE AND MAINTENANCE using the Currie “Smart Charger”, we recommend that you do not leave the Not doing any and/or all of the following may lead to reduced performance charger plugged in for more than 24 and/or permanent damage to the batteries. - Page 10 ® ® Currie Technologies Currie Technologies THROTTLE AND bRAkE OPERATION & ADjUSTMENT RAbbIT-TURTLE SWITCH THROTTLE OPERATION This switch limits the top speed of the Scoot-E. The top speed can vary from The speed of the Electro-Drive™ less than 2mph (dial turned all the way to the left) up to 10mph (dial turned scooter is controlled by a grip- twist throttle, which is located on the handlebar.
- Page 11 ® ® Currie Technologies Currie Technologies higher top end speeds and therefore have a higher load when starting from brake cable. WARNING a dead stop versus scooters with belt or chain drive, which have a lower top end speed. The higher gear ration of the DD scooters will cause the Red LED All brakes need periodic adjustment.
-
Page 12: Wheel Removal
® ® Currie Technologies Currie Technologies DRIvE TRAIN ASSEMbLY WHEEL REMOvAL The DD scooter series is equipped with the fRONT WHEEL REMOvAL Currie Technologies ® Direct Drive propulsion system, the finest available in today’s rapidly 500DD, 750DD, 1000DD AND SCOOT-E growing personal electric transportation DD SERIES SCOOTERS market. - Page 13 ® ® Currie Technologies Currie Technologies REAR WHEEL & DRIvE ASSEMbLY REMOvAL 500DD, 750DD AND 1000DD SERIES SCOOTERS Turn the power switch to the “OFF” position. Remove and disconnect the battery pack. Disconnect the motor connector (located in the battery tray compartment).
-
Page 14: Wheel Installation
® ® Currie Technologies Currie Technologies WHEEL INSTALLATION REAR WHEEL INSTALLATION fRONT WHEEL INSTALLATION: 500DD, 750DD AND 1000DD SERIES SCOOTERS 500DD, 750DD, 1000DD AND SCOOT-E DD SERIES SCOOTERS The order of this installation is very important. If your scooter is equipped with a Align the RIGHT bearing cap holes with the threaded holes on the V-Brake you will need to disengage it frame. -
Page 15: Flat Tire Repair
® ® Currie Technologies Currie Technologies Secure with washer and nut. 11. Slide the axle through one half of the rim, and place the center fLAT TIRE REPAIR (longer) axle sleeve over the axle at the center of the two rim halves. SCOOT-E DD SERIES SCOOTERS - 12. - Page 16 • HOW fAR WITH THE ELECTRO-DRIvE™ SCOOTER GO ON A fULL fRONT AND REAR WHEEL CHARGE? Maximum range per charge for the 500DD series scooters is 8 miles (13 500DD, 750DD km), 750DD and 1000DD series scooters is 12 miles (19 km) and the...
- Page 17 ® ® Currie Technologies Currie Technologies Section 6 - PRE-RIDE CHECkLIST WARNING Never inflate a tire beyond the maximum pressure imprinted on the sidewall It is recommended that you perform each of these checks before each and every ride. • HOW OfTEN SHOULD I RECHARGE THE bATTERIES? TIRES □...
- Page 18 ® ® Currie Technologies Currie Technologies FCC INSTRUCTIONS FCC Warning for the battery charger Warning: Changes or modifications to the charger not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Need help?
Do you have a question about the 500DD Series and is the answer not in the manual?
Questions and answers