eZip e400 Assembly Manual

Included in your parts box:

•
Toolkit (4+5mm combo hex wrench,
13+15mm combo open-end wrench)
•
Touch-up paint
•
Reflectors (if not already installed)

Required Tools (not included):

•
Scissors or wire cutters
•
10mm open-end wrench (may be
needed)
Scooter won't turn on (no lights • 5-minute auto shutoff feature has activated; turn scooter off then
on throttle) on again
• Battery not charged
• Battery may not be connected from factory. Remove your
scooter's deck plate using the thumb screw under the on/off
switch, connect the battery, then replace the plate
• The scooter's fuse may be blown. See your owner's manual for
more information on locating and replacing this fuse, or call our
Customer Service line for help

Brakes rub when riding

• Some brake noise is normal and will not detract from your
scooter's performance
• If the brake rubbing is severe, you can re-adjust the brakes,
referring to owner's manual and to the small manufacturer's
booklet attached to the brake itself.
Can someone help me with...? Call the Currie Technologies technical and customer service
department at 1-800-377-4532
Currie Technologies Technical and
1.800.377.4532
Customer Service