Warranty - Pro-Ject Audio Systems 1 Xpression Carbon Classic Instructions For Use Manual

Potential incorrect use and fault conditions
Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls
before leaving the factory. Faults that may possibly occur are not necessarily due to material or
production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore
the following list of common fault symptoms is included.
The platter doesn't turn although the unit is switched on:
The unit is not connected to the mains power supply.
No mains at the socket.
Drive belt is not fitted or has slipped off.
No signal through one or other channel or both channels:
No signal contact from the cartridge to the internal tonearm wiring or from that to the arm lead or
from that to the phono box or between that and the amplifier. This could be due to a faulty plug,
broken wire or solder joint or simply loose plug/socket connection.
Phono input not selected at amplifier.
Amplifier not switched on.
Amplifier or speakers defective or muted.
No connection to the loudspeakers.
Strong hum on phono input:
No earth connection from cartridge or arm or arm cable to amplifier, or earth loop.
Distorted or inconsistent sound from one or both channels:
Record player is connected to wrong input of amplifier, or MM/MC switch incorrectly set.
Needle or cantilever damaged.
Wrong r.p.m., drive belt overstretched or dirty, platter bearing without oil, dirty or damaged.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above
information, please contact your dealer for further advice. Only when the problem cannot be resolved
there should the unit be sent to the responsible distributor in your country.
Guarantee repairs will only be effected if the unit is returned correctly packaged. For this reason we
recommend keeping the original packaging.
Never return a record player without making sure that is it safely disassembled and correctly packaged
in the original packaging according to the diagrams on the last page of this user guide. Please remove
these parts and pack them separately: lid (10), counterweight (6), anti-skating weight (16) platter (5)
and belt (3). Fit the cartridge protection cap. Insert the transport lock for the tonearm (18) prior to
carefully packaging the record player.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these
instructions for use and/or by transportation without the original packaging. Modification or
change to any part of the product by unauthorized persons release the manufacturer from any
liability over and above the lawful rights of the customer.
PRO-JECT is a Registered Trademark of H.
Lichtenegger.
This guide was produced by: Pro-Ject Audio
©
Systems Copyright 2013. All rights reserved.
8
© Pro-Ject Audio Systems · Pro-Ject 1 Xpression Carbon Classic / Ortofon 2M SILVER · Revision 2014.01.03
The information was correct at the time of going
to press. The manufacturer reserves the right to
make changes to the technical specification
without prior notice as deemed necessary to
uphold the ongoing
development.
process of technical