Table of Contents
Advertisement
: Select separate AF points
The AF area selection mode and manually-selected AF point (or Zone)
can be set separately for each camera orientation (1. Horizontal, 2.
Vertical with the camera grip at the top, 3. Vertical with the camera grip
at the bottom). Convenient when, for instance, you want to keep using
the right AF point during all camera orientations.
When you manually select the AF area selection mode and AF point (or
Zone with Zone AF) for each of the three camera orientations, they will
be set for the respective orientation. Whenever you change the camera
orientation, the camera will switch to the AF area selection mode and
manually-selected AF point (or Zone) set for that orientation.
If you clear the camera settings to their defaults (p.58), the setting will be
[Same for both vert/horiz]. Also, your settings for the three camera
orientations will be cleared and all settings will revert to Single-point AF
(Manual selection) with the center AF point selected.
25
Manual AF point selection pattern
During manual AF point selection, the selection can either stop at the
outer edge of the area AF frame or it can move to the opposite AF point.
This function works in AF area selection modes other than 61-point
automatic selection AF and Zone AF. (It takes effect in 61-point
automatic selection AF only with AI Servo AF.)
3 Customizing AF Functions
: Stops at AF area edges
Convenient if you often use an AF point
along the edge.
: Continuous
Instead of stopping at the outer edge, the
selected AF point continues to the
opposite side of the area AF frame.
99
Advertisement
Table of Contents
