Replacing The Chain If It "Pops Off - Honda Minimoto Maxii Instruction Manual

Replacing the
Chain if it "pops
off":
It is possible that under
extreme conditions the
chain may pop off. If this
occurs, the motor will run
but the rear wheel will not
turn under power.
The chain can be replaced
onto it's original position by
following these
instructions:
WARNING: Whenever
removing the protective
chain cover, YOU MUST DIS-
CONNECT the battery. This
will ensure no possibility of
the motor or chain running
18
accidentally while working in
this area. Refer to the sec-
tion on "Replacing
the battery" in this instruc-
tion manual for this opera-
tion.
1) Support the bike so that
the rear wheel is not touch-
ing the ground (Fig 20).
IMPORTANT: Make sure the
bike will not fall over in this
process. Work on a work
bench or in a area with
plenty of space.
Fig 20
MINIMOTO MAXII BIKE
™
2) Remove the outer cover
by loosening the two
phillips head screws (Fig
21and 22).
Fig 21and22
Fig 23and24
3) Use a Phillips head
screw driver to separate the
Upper and Lower (Fig 23
and 24).
4) Place the chain over the
MOTOR gear first. Use your
fingers to keep some
tension on it (Fig 25).
Fig 25
5) Place the chain on the
top of the rear wheel gear
about half way around
(Fig 26).
Fig 26
6) Carefully move the
wheel and gear so that the
entire chain pops back on
(Fig27).
Fig 27
7) Replace the chain
covers in reverse order.
8) Reconnect the battery.