Brant Radiant Heaters AVS-40N Instructions Manual page 27

AVS Series
Attach the flexible connector to the adapter and burner control box inlet. Seal the joints.
4
NOTE: Excessive torque on the manifold may misalign the orifices. Always use two wrenches to
tighten mating pipe connections. Final assembly must be tested for gas leaks according to NFPA 54
and all local codes and/or Standards.
Testing for gas leaks with an open flame or other sources of ignition may lead to a
fire or explosion and cause serious injury or death. Test in accordance with NFPA
or local codes.
Figure 3.19 • Gas Connection (Approved Flexible Gas Connection)
Burner
Control Box
Side View
Figure 3.20 • Gas Connection (Approved Flexible Gas Connection)
Adapter
Drip Leg/
Sediment Trap
WARNING
!
Ball Valve / Inlet Tap
Heater Movement/Expansion
Type 1 Hose Gas Connector, formed into a U-bend
Ball Valve / Inlet Tap
Adapter
Elbow Elbow
 
Type 1 Hose Gas Connector, formed into a U-bend
• Control Box Side View
• Control Box Back View
Burner Control Box
End View
27
3.0 Installation • Gas Supply