Sharp Aquos LC-70UD1U Operation Manual page 32

Enjoying 3D image Viewing
p
2D _ 3D * Converts normal 2D images into 3D images.
Creates 3D images from 3D images displayed side by side.
3D mode The image is splk into a left and right image, and then the
(using the Side by Side images are stretched and displayed sequentially to create
3D Glasses) a 3D image.
Creates 3D images from 3D images displayed on the
top and bottom. The image is splk into a top and bottom
Top and Bottom image, and then the images are stretched and displayed
sequentially to create a 3D image.
Side by Side _ * Creates 2D images from 3D images displayed side by side.
2D mode 2D Only the left image is stretched and displayed. The image
(without does not appear in 3D.
using the _ Creates 2D images from 3D images displayed on the
3D Glasses) Top and Bottom
top and bottom. Only the top image is stretched and
,2D
displayed. The image does net appear in 3D.
5 Take off the 3D Glasses and turn off the power.
The TV screen may temporarily become black when
the TV is trying to detect a 3D image signal and when
swkching from 3D to 2D mode.
The image signal may centain a 3D identification
signal. You can enable the TV to automatically detect
the 3D irr_age type by selecting "System Options"
> "3D Setup" > "3D Aute Change" on the TV. (See
page 31 ,)
1 When "3D Auto Change" is set to "Mode 1"
or "_ode 2"
* The 3D image type is detected automatically and
the appropriate 3D image is displayed.
if the input signal swkches to 2D, 2D images are
displayed automatically.
3D mode is canceled automatically when the setting is
changed, input selection is changed, or the power is
turned off.
1 Press 3D,
A screen appears prompting you to select
between 3D and 2D image viewing.
2 Press -_1/1_to select "3D" or "2D", and then
press ENTER.
To view in 3D mode: Select "3D", and then go to
step 3.
To view in 2D mode: Select "2D", and then go to
step 6.
3 Press _1/1_ to select the 3D signal type
("2D .3D", "Side by Side" or "Top and Bottom")
and then press ENTER,
When "3D Auto Change" is set to "Off"
The following message is displayed. Press 3D.
Press _1/1_to select the "Yes", and then press
ENTER.
2 Turn on the 3D Glasses and place them on your
head,
:3 You can now view 3D images.
4 Press 3D during the 3D mode.
Select "Yes" and press ENTER to switch to 2D
mode.
Take off the 3D Glasses and turn off the power.
If you select the same system as that of the input
signal, 3D images are displayed.
4 Turn on the 3D Glasses and place them on your
head.
5 You can now view 3D images.
6 Press _1/_- to select the 213skjnal type ( "Side
by Side" or "Top and Bottom") and then press
ENTER,
If you select the same system as that of the input
signal, 2D images are displayed.
o Take off the 3D Glasses and turn off the power.
Take off the 3D Glasses and turn off the power.
_- 30