Audiovox AVX1B4S Programming Manual

Transmitter Programming Guide
This transmitter is designed for use with your upgrade
remote start unit and is programmed by using the remote
start's program switch in combination with the transmitter
button. Although this transmitter can be programmed
into any of the Audiovox remote start and or alarm, alarm
remote start systems, it will offer limited use and should
be used for the remote start upgrade only.
To program this transmitter into your remote start upgrade
unit:
1) Turn the ignition to the on position
2) Press and release the programming switch 3 times
3) Press and hold, for 3 seconds, the button of the
transmitter you wish to add until the parking light
flashes indicating the transmitter has been learned.
4) Repeat step 3 for each transmitter up to a total of 4.
Turn the ignition off to exit the program mode.
NOTE: Do not allow more than 15 seconds to lapse
between steps or the program mode will be automatically
exited and you will have to start over.
Model AVX1B4S
128-6833
1 of 2