Related Manuals for Clarke PIONEER 215
Summary of Contents for Clarke PIONEER 215
- Page 1 PIONEER 215 PIONEER 215 AIR COMPRESSOR AIR COMPRESSOR OPERATION & MAINTENANCE INSTRUCTIONS © 1207...
-
Page 2: Table Of Contents
Thank you for purchasing this air compressor which is fitted with a 10 litre air receiver. Please read this leaflet thoroughly and carefully follow all instructions. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to the compressor giving you long and satisfactory service. -
Page 3: Safety Precautions
If low pressure parts are used, the air pressure could cause them to explode For spare parts and service, please contact your nearest dealer, or Clarke or fly apart, resulting in serious injury. Always take great care when releasing International, on one of the following numbers. - Page 4 SAFETY PRECAUTIONS PARTS DIAGRAM TRAINING: Prior to use all operators should become familiar with the instructions in this booklet. In particular, become familiar with the ON/OFF control for emergency stopping. ALWAYS USE EYE PROTECTION: When operating the air compressor, always use eye protection, and make sure that other people in the work area are also using eye protection.
-
Page 5: Specifications
SPECIFICATIONS SAFETY PRECAUTIONS STORE THE AIR COMPRESSOR PROPERLY: When not in use the air compressor Electrical Supply ........230 V, 1 Phase 50Hz should be stored in a secure, dry place out of the reach of children. Always lock Max. Operating Pressure ....... 10 bar / 145 psi up the storage area. -
Page 6: Trouble Shooting
Clarke dealer. NEVER USE AN AIR COMPRESSOR WHICH APPEARS DEFECTIVE OR IS OPERATING ABNORMALLY: If the compressor operates unusually or makes strange noises, switch off immediately and purge the air tank. -
Page 7: Routine Maintenance
After the first 100 hours use, replace the CHECK FOR DAMAGED PARTS AND AIR LEAKS: If any part of the compressor is oil completely using Clarke SAE40 damaged, it should be carefully checked to determine that it will operate compressor oil. Then replace the oil after correctly and perform its intended function. -
Page 8: Warning Symbols
Ensure the oil level is between the min and max marks on the dipstick. See page 11 and top-up if necessary - (use Clarke SAE 40 compressor oil, available from your local dealer). Risk of accidental start-up. The compressor could start... -
Page 9: Operating Instructions
OPERATING INSTRUCTIONS ELECTRICAL CONNECTIONS Draining the reservoir Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved 13 amp BS 1363 plug, or a suitably fused isolator switch. CAUTION! It is important to drain the reservoir before storage WARNING! THIS APPLIANCE MUST BE EARTHED IMPORTANT: The wires in the mains lead are coloured in accordance with Switch the air compressor off, by pressing down the red on/off button, and... -
Page 10: Parts Identification
PARTS IDENTIFICATION OPERATING INSTRUCTIONS Switching the air compressor OFF To switch the air compressor off, Close the outlet tap and press down on the on/off button (red button) located on top of the pressure regulator Switch off the mains supply and remove the plug. •... -
Page 11: Assembly
OPERATING INSTRUCTIONS ASSEMBLY WARNING! Switching the air compressor ON Before assembling and using the air compressor, make sure that you have The compressor will make a continuous loud noise when the tank is charging - read and understood all of the safety instructions. this is normal. -
Page 12: Preparation For Use
2. Ensure the oil level is between the min and max marks on the dipstick. See figure 3. • If needed top up the reservoir with Clarke SAE 40 compressor oil, Attach the air hose to the air outlet tap available from your Clarke dealer.
Need help?
Do you have a question about the PIONEER 215 and is the answer not in the manual?
Questions and answers