Pro Cinema LS10500
Quick Setup
Before using the projector, make sure you read the safety instructions in the
online User's Guide.
Choose a location
Keep the projector level and place it at a
height so its lens is even with the top or
bottom of the screen and is centered
horizontally. If this isn't possible, use the
lens shift feature or the keystone
correction button on the projector to
reposition the image (see "Adjust the
image").
To view 3D images correctly, RF 3D
glasses must be worn within 32 feet
(10 m) of the projector. Use the image to
determine the viewing distance for 3D projection
(the shading represents the 3D viewing area):
For more information on where to place your projector, see the online User's
Guide.
Connect the projector
Follow the steps below to connect a video device. For additional connection
types, see the online User's Guide.
1
Loosen the two screws at the bottom of the cable cover, then pull the
cover forward.
2
Remove the cable cover from the grooves at the top of the projector.
3
Connect multiple video devices and use the Source buttons on the remote
control or the Source button on the projector to switch between them.
HDMI cable
Component video
cable
RCA video cable
Turn on your equipment
1
Turn on your video source.
2
Plug in the projector.
3
Press the
power button on the projector or the On button on the
remote control. The shutter opens and the power light flashes blue,
then stays on.
Note: To shut down the projector, press the
projector or the Standby button on the remote control.
4
The default language of the menu system is English. To select another
language, press the Menu button on the projector or remote control.
Select Settings and press Enter. Select Language and press Enter. Select
your language and press Enter. Press the Menu button to exit.
Using the remote control
Install two AA batteries as shown.
Turn projector on
Choose which source
to display
Control connected
sources with
HDMI Link
Adjust zoom, focus,
and lens shift
Access projector menus
Change the
3D format
For more information on using the remote control, see the online User's Guide.
power button on the
Turn projector off
Turn projector
display off
Switch between
2D and 3D
Navigate projector
menus
Display test pattern