Tools For Installation; Selection Of Installation Location - Friedrich MWM18Y3J Installation And Operation Manual

Tools for installation

1. Level
4. Drill head
7. Open-end wrench
10. Vacuum pump
13. Allen/spanner wrenches
Note:
● Please contact a local qualified installer for installation.
● Ensure power cords are rated for use with equipment.

Selection of installation location

Basic requirement
Installing the unit in the following
locations may cause operational issues
with equipment. If unavoidable seek
assistance from local dealer.
1. Any location with an excessive heat
source, where flammables, gasses or
volitile flyings exist.
2.
Any location with high-frequency
devices (such as welding machine,
medical equipment).
3.Coastal locations.
4.Corrosive or spaces that are excessivly
wet, such as pool rooms, laundry and
bath rooms.
Outdoor unit
1.
Be considerate of installed location due to hot airflow from unit and any noise that it
may create.
2. Location should be well ventilated and dry, outdoor unit not to be exposed
directly to sunlight or strong wind.
3. The location should be able to withstand the weight of outdoor unit.
4.
Ensure installation conforms to installation diagram.
5.
Select a location which is out of reach for children and far away from animals or
plants. If it is unavoidable, please add the fence for purpose of safety.
2. Screw driver
5. Pipe expander
8. Pipe cutter
11. Manifold gauges
Indoor unit
1.
There should be no obstruction near air inlet
and air outlet.
2. Location should have acceptable condensate
disposal considerations.
3.
Select a location which is out of reach for
children.
4. Installed location should be rated for the
weight of equipment and not create
vibration or noise.
5. The appliance must be installed 8 Ft
above floor.
Do not install directly above heat source or
6.
electrical appliance.
17
3. Impact drill
6. Torque wrench
9. Leakage detector
12. Multimeter
14. Measuring tape