Table of Contents
Advertisement
CAUTION
The alternator is not a battery charger.
The alternator is designed to maintain
proper electrical system voltage. A
battery with a low state of charge, or a
dead battery, may overheat and damage
the alternator.
SteerIng colUmn
Tilt & Telescope
Tilt and telescope steering wheel control lever
is located on the steering column.
To Tilt the Steering Wheel:
Pull the lever up and tilt the steering
wheel to the desired level.
Release the lever to lock the steering
wheel in the new position.
To Telescope the Steering Wheel:
Push and hold the lever down.
Move the steering wheel to the desired
location.
Release the lever to lock the steering
wheel in the new position.
Turn Signal Indicator and Headlight High/
Low Dimmer Control:
Both are located on the steering column.
Push the lever forward to activate right
turn indicator circuits when ignition is
on.
Pull the lever back to activate left turn
indicator circuits when the ignition is on.
Pull the lever up to select high/low beam
circuits when the headlights are on.
NOTE
An audible sound is heard when turn
signals are activated. Applying the foot
brake cancels the turn signal sound,
releasing the foot brake activates the
audible turn signal sound.
Hazard Flashers:
The flasher button is located on the steering
column.
To turn on the four way flashers, pull out
on the flasher button.
To turn off the flashers, push the button
in.
Turning on the hazard flashers activates
the rear view camera.
Turn Signal on Mirror:
A turn signal indicator
is found on each mirror.
Upon activation of a
turn signal the indicator
will blink.
The indicator light is
mounted on the side of
the mirror.
090243
031210i
2 00 8 K nI G h t
electrIcal systems - chassIs — 9
conSole
NOTE
Switch and component placement on
panels may vary.
Transmission Shift Selector
The keypads on the shift
control are R (Reverse),
N (Neutral), D (Drive),
Arrow up, Arrow down,
Mode button. A digital
display window shows
gear selection, various
transmission modes, oil
level and transmission
fault codes. Generation 4
keypads have a split screen
displaying two number
sets while in drive. The
left number displays the highest forward range
available. The right number is the range that the
transmission is currently in. NN (Neutral) will
appear in the display window when the ignition
is turned On. This indicates the transmission
is in neutral and it is safe to start. If the NN
does not display when the ignition is turned on,
there is no power to the shift selector and the
transmission will not allow the engine to start.
No display is an indicator of electrical problems
with the engine batteries, ECU or the shift
selector.
080355g
1
Advertisement
Chapters
Table of Contents
Troubleshooting
