Memory Clock - Gigabyte GA-78LMT-USB3 User Manual

& HT Link Frequency
Allows you to manually set the frequency for the HT Link between the CPU and chipset.
Auto
x1~x10
& Set Memory Clock
Determines whether to manually set the memory clock. Auto lets BIOS automatically set the memory clock
as required. Manual allows the memory clock control item below to be configurable. (Default)
& Memory Clock
This option is configurable only when Set Memory Clock is set to Manual. Options are: X4.00, X5.33,
X6.66, X8.00.
& DRAM Configuration
DCTs Mode
DDR3 Timing Items
x 1T/2T Command Timing
x CAS# latency
x RAS to CAS R/W Delay
x Row Precharge Time
x Minimum RAS Active Time
x TwTr Command Delay
x Trfc0 for DIMM1, DIMM3
x Trfc1 for DIMM2, DIMM4
x Write Recovery Time
x Precharge Time
x Row Cycle Time
x RAS to RAS Delay
Channel Interleaving
Bank Interleaving
DQS Training Control
Memclock tri-stating
: Move Enter: Select
F5: Previous Values
& DCTs Mode
Allows you to set memory control mode.
Ganged
Unganged
& DDR3 Timing Items
Manual allows all DRAM timing control items below to be configurable.
Options are: Auto (default), Manual.
& 1T/2T Command Timing
Options are: Auto (default), 1T, 2T.
& CAS# latency
Options are: Auto (default), 4T~12T.
& RAS to CAS R/W Delay
Options are: Auto (default), 5T~12T.
& Row Precharge Time
Options are: Auto (default), 5T~12T.
& Minimum RAS Active Time
Options are: Auto (default), 15T~30T.
BIOS will automatically adjust the HT Link Frequency. (Default)
Sets HT Link Frequency to x1~x10 (200 MHz~2.0 GHz).
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
DRAM Configuration
[Unganged]
[Auto]
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
[Enabled]
[Enabled]
[Skip DQS]
[Disabled]
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Sets memory control mode to single dual-channel.
Sets memory control mode to two single-channel. (Default)
SPD Auto
-- --
9T 9T
9T 9T
9T 9T
24T 24T
5T 5T
110ns 110ns
-- --
10T 10T
5T 5T
33T 33T
4T 4T
F10: Save
- 27 -
Item Help
Menu Level `
ESC: Exit F1: General Help
F7: Optimized Defaults