Mb Intelligent Tweaker(M.i.t.) - Gigabyte GA-78LMT-USB3 User Manual

2-3

MB Intelligent Tweaker(M.I.T.)

` IGX Configuration
CPU Clock Ratio
CPU NorthBridge Freq.
Core Performance Boost
(Note)
CPB Ratio
Turbo CPB (Note)
CPU Host Clock Control
x CPU Frequency(MHz)
PCIE Clock(MHz)
HT Link Width
HT Link Frequency
Set Memory Clock
x Memory Clock
` DRAM Configuration
******** System Voltage Optimized ********
System Voltage Control
x NorthBridge Volt Control
x DDR3 Voltage
x CPU Voltage Control
x CPU NB VID Control
Normal CPU Vcore
Normal CPU Vcore NB
: Move Enter: Select
F5: Previous Values
Whether the system will work stably with the overclock/overvoltage settings you made is dependent
on your overall system configurations. Incorrectly doing overclock/overvoltage may result in damage
to CPU, chipset, or memory and reduce the useful life of these components. This page is for advanced
users only and we recommend you not to alter the default settings to prevent system instability or
other unexpected results. (Inadequately altering the settings may result in system's failure to boot. If
this occurs, clear the CMOS values and reset the board to default values.)
& IGX Configuration
Internal Graphics Mode
UMA Frame Buffer Size
x Surround View
Onboard VGA output connect
VGA Core Clock control
x VGA Core Clock(MHz)
: Move Enter: Select
F5: Previous Values
& Internal Graphics Mode
Allows you to determine whether to allocate system memory for the onboard graphics controller.
Disabled
UMA
& UMA Frame Buffer Size
Frame buffer size is the total amount of system memory allocated solely for the onboard graphics controller.
MS-DOS, for example, will use only this memory for display. Options are: Auto (default), 128MB, 256MB,
512MB, 1024MB.
(Note) This item is present only when you install a CPU that supports this feature.
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
MB Intelligent Tweaker(M.I.T.)
(Note)
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
IGX Configuration
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Disables the onboard graphics controller.
Allocates memory for the onboard graphics controller from the system memory. (Default)
[Press Enter]
[Auto] 2800Mhz
[Auto] 2000Mhz
[Enabled]
[Auto] 3100Mhz
[Disabled]
[Auto]
200
[Auto]
[Auto]
[Auto] 2000Mhz
[Auto]
x6.66 1333Mhz
[Press Enter]
[Auto]
Auto
Auto
Auto
Auto
1.3250V
1.2000V
F10: Save
[UMA]
[Auto]
Disabled
[Auto]
[Auto]
350
F10: Save
- 25 -
Item Help
Menu Level `
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level ``
ESC: Exit F1: General Help
F7: Optimized Defaults