DMX Pandora Setup Manual page 11

2 Login to the Online Control Panel.
3 Click Administration in the top right corner, then select the Network tab.
4 In the Wi-Fi Quick Setup section, click Start. The player will be in the Wi-Fi Quick
Setup mode for two minutes.
5 Press the WPS button on your router or access point within the two-minute period.
6 When a connection has been established, you will receive the following message:
"Wi-Fi Quick Setup successfully configured the wireless interface. " If the
router is not detected, wait a moment and try again starting from step 4.
NOTE: Depending on the security of the router, it may not be possible
to use the Wi-Fi Quick Setup. In this case, follow the instructions to manually
configure Wi-Fi above.
7 Proceed to below Test Connection section and follow the steps.
RECYCLE THE POWER
Press the Power button on the back of the player to the 'off' position.
1
2 Disconnect Ethernet cable from the player.
3 Wait 5 seconds, and then press the Power button on the back of the player to the
'on' position.
TEST CONNECTION
1 Login to the Online Control Panel through the player's wireless IP address.
2 Click Administration in the top right corner of the screen and then select the
Update tab.
3 Click Test Connection. It may take a few minutes for the four digit install PIN
code to be displayed. A message will be displayed if any errors exist.
NOTE: If you receive an error message, please contact us at 800.929.5407.
ProFusion iO Pandora Quick Start Guide 11