ADJ Inno Spot Elite User Instructions page 7

Inno Spot Elite
press ENTER. Either "Slave 1" or "Slave 2" will be displayed.
2. Press the UP or DOWN buttons until your desired slave
mode is displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can make one
fixture the Master and then set the next fixture to "Slave 2", the
fixtures will now have contrast movement to each other.
Black Out
- This mode can be used as a precaution
mode, that in case the DMX signal is lost, the operating
mode chosen in the setup is the running mode the fixture will
go into when the DMX signal is lost. You can also set this as
the operating mode you would like the unit to return to when
power is applied.
1. Press the MENU button until "Black Out" is displayed, press
ENTER.
2. Either "M/S" (Master/Slave), "Hold", or "Black Out" will be dis-
played. Choose an operating mode you would like the unit to
start up in when power is applied or the DMX signal is lost.
• M/S - If the DMX signal is lost or power is applied, the unit will
automatically go into Master Slave mode.
• Hold - If the DMX signal is lost the fixture will stay in the last
DMX set up. If power is applied and this mode is set, the unit will
automatically go into the last DMX set up.
• Black Out - If the DMX signal is lost or power is applied, the unit
will automatically go into stand by mode.
3. Press ENTER to confirm your desired set up.
Sound State
- In this mode the unit will run in sound
active mode.
1. Press the MENU button until "Sound State" is displayed, press
ADJ Products, LLC - www.adj.com - Inno Spot Elite Instruction Manual Page 12
Inno Spot Elite
System Menu
ENTER.
2. Either "On" or "Off" will now be displayed. Use the UP or
DOWN buttons to toggle between "On" and "Off".
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
sensitivity of the sound active mode.
1. Press the MENU button until "Sound Sense" is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
Pan Inverse
1. Press the MENU button until "Pan Inverse" is displayed,
press ENTER. Either "Yes" or "No" will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until "Yes" is displayed, press ENTER to confim. To deactivate
Pan inversion, select "No" and press Enter.
Tilt Inverse
1. Press the MENU button until "Tilt Inverse" is displayed, press
ENTER. Either "Yes" or "No" will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until "Yes" is displayed, press ENTER to confim. To deactivate
Tilt inversion, select "No" and press Enter.
- In this mode you can adjust the sound
- Pan Inversion
- Tilt Inversion
ADJ Products, LLC - www.adj.com - Inno Spot Elite Instruction Manual Page 13
System Menu