ADJ LED UV GO User Instructions page 5

LED UV GO
2. Either "CHAR", "LOAD", or "STAT" will be displayed. Use the
UP or DOWN buttons to scroll through the functions, and press
ENTER to select your desired function.
• CHAR (Charging) - When this is selected you are able to charge
or stop charging the battery. When a power cable is connected
and "ON" is selected, the battery is now being charged. To stop
charging, select "OFF".
• LOAD (LED On or OFF) - This will let you blackout the LED while
charging. Select "OFF" to blackout the LED or "ON" to stop the
LED blackout.
• STAT (Charge Status) - This will let you check the battery status.
3. Press ENTER to confirm your setting and exit.
FHRS
- With this function you can display the running
time of the unit.
1. Press the MENU button until "FHRS" is displayed, press
ENTER.
2. The running time of the fixture will now be displayed. Press
MENU to exit.
VER
- This will display the software version
1. Press the MENU button until "VER" is displayed. Press the
ENTER button and the software vesion will be displayed.
2. Press the MENU button to leave this function.
ADJ Products, LLC - www.adj.com - LED UV GO Instruction Manual Page 8
System Menu LED UV GO
The UC-IR infrared remote has many differnet functions and gives
you complete control of your LED UV GO. To control the your desired
fixture you must aim the controller at the front of the fixture and be no
more the 30 feet away.
STAND BY - Pressing this button will blackout the fixture.
FULL ON - Hold this button down to fully light up the unit. When you
let the button go, the unit will return to its previous state.
COLOR - Press this button to enter Dimmer mode. Adjust the output
intensity using either the number buttons, or using the "DIMMER +"
and "DIMMER -" buttons.
STROBE - This button will activate the strobe effect. You can control
the flash rate by pressing the "DIMMER +" and "DIMMER -" buttons.
If you press and hold this button the unit will begin to strobe.
SPEED - Press this button and use the "+" & "-" buttons to adjust the
speed of the Auto run.
SOUND ON & OFF - These buttons activate and deactivate the
sound active mode.
SHOW - This designates the fixture as a slave fixture in a master/
slave configuration.
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the out-
put intensity and to adjust the strobe speed.
ADJ Products, LLC - www.adj.com - LED UV GO Instruction Manual Page 9
UC-IR Operation