Rip - Planet ADE-4400 User Manual

Field
Enable
Destination
Subnet Mask
Next Hop
Metric
Interface
Add Route
Update
Delete Selected
Show Routes
Static Route Table A list of the previously configured static IP routes.

3.6.2.3 RIP

Click RIP in the left pane, the page shown in the following figure appears. If you are using
this device as a RIP-enabled router to communicate with others using Routing Information
Protocol (RIP), enable RIP. This page is used to select the interfaces on your devices that
use RIP, and the version of the protocol used.
Description
Select it to use static IP routes.
Enter the IP address of the destination device.
Enter the subnet mask of the destination device.
Enter the IP address of the next hop in the IP route to
the destination device.
The metric cost for the destination.
The interface for the specified route.
Click it to add the new static route to the Static Route
Table.
Select a row in the Static Route Table and modify the
parameters. Then click it to save the settings
temporarily.
Select a row in the Static Route Table and click it to
delete the row.
Click it, the IP Route Table appears. You can view a list
of destination routes commonly accessed by your
network.
48