Hotpoint HUI 62 TK Instructions For Installation And Use Manual page 28

Care and Cleaning
Cleaning the glass doors
GB
DROP DOWN DOORS
inner and middle glass panels are removed , the door
slams shut.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down
doors.
The glass panels may now be washed at the sink.
Stubborn stains can be removed by using a fine steel
wool soap pad.
Replace in the reverse order.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
28
Open the door fully and
carefully slide the first inner
glass towards you, taking
care not to allow the glass
to fall.
If necessary, the glass can
be pushed delicately from
the back side.
Repeat the same procedure
with the next glass.
Now the external glass
panel can be washed.
WARNING! As soon as the
Open the lower door
and lift out the inner
door glass
Remove the two rubber
anti-rattle bungs
R e m o v e t h e c e n t r e
glass taking care to
support the weight
o f t h e g l a s s w h e n
removing and fitting
Ensure anti-rattle bungs are fitted before fitting inner door
glass.
BE CAREFUL NOT TO DAMAGE THE GLASS PANELS BY
PUSHING THEM TOO HARD.
When fitting the glass make sure it is fitted correctly ie
reflective face is fitted the right way round.
Ensure the glass panel is not subjected to any sharp
mechanical blows. Take particular care not to damage
the inner surface which is coated with a heat reflective
layer. After cleaning, rinse and dry with a soft cloth. For
slight soiling the inner glass panel may be cleaned, while
still warm, without removing it from the door
Warning: Oven must not be operated with inner door
glass removed.
Anti- rattle bung
The door glass is equipped with anti-rattle bungs
to lose the bungs when
cleaning
Door and Control Panel (Glass)
Regularly wipe with a clean, damp cloth and polish with
a clean, dry cloth.
Door and Control Panel Trims (Stainless Steel)
Regularly wipe with a clean, damp cloth and polish with
a clean, dry cloth.
Replacement of the Oven Light
WARNING: Ensure that the appliance is switched off
before replacing the lamp to avoid the possibility of
electric shock.
Unscrew the glass cover, using a suitable cloth to protect
the fingers and remove carefully. Unscrew the existing
light bulb, and remove. Screw the new bulb into position
and replace the glass cover, with metal washer, until
positioned securely.
which prevents rattling of
the glass when opening and
shutting the oven main door.
These can be removed for
washing.
WARNING : Be careful not