Download Print this page

Part List; Specifications - Kenwood CX-DAB1 Installation Manual

Dab antenna unit
Hide thumbs

Advertisement

CAUTION
Disconnect the battery's negative terminal
and make all electrical connections before
installing the unit.
Mounting and wiring this product requires
skills and experience. For safety's sake, leave
this work to professionals. If you experience
problems during installation, consult your
Kenwood dealer.
This film antenna is exclusively for use inside
the vehicle.
Do not install at the following locations:
– Where it may block driver's view
– Where it may obstruct operation of safety
devices such as air bags
– On movable glass surface such as rear
hatch
Signal strength will decrease at the following
locations:
– On IR reflecting glass or where covered
with mirror type glass film
– Where it overlaps with genuine radio
antenna (pattern)
– Where it overlaps with window heating
wires
– At side of vehicle (e.g. door, front quarter
window)
– On rear window
– When glass that blocks radio signals (e.g.
IR reflecting glass, thermal insulation glass)
is used
– Reception may decrease due to noise
when windshield wiper, air conditioner, or
motor is turned on.
– Reception may decrease depending on
the direction of the broadcast station with
respect to the vehicle (antenna).
Be sure to check the installation location
of film antenna A before installing. Film
antenna cannot be re-pasted.
Thoroughly wipe oil and dirt from the
pasting surface with the included cleaner D.
Do not bend or damage the film antenna A.
Warm the pasting surface by turning on the
heater for example, before applying.
2
|
English
It may not be possible to install on some
type of vehicle.
Check the cable routing of the film antenna
A and amplifier B before pasting.

Part list

A .......................... DAB antenna film (×1)
B .............. DAB antenna amplifier (×1)
C ...................................Cord clamper (×3)
D .................................................Cleaner (×1)

Specifications

Frequency Range: 170
Impedance: 50Ω
Operating voltage: 9
Current Consumption: 70mA (Max)
Connector Type: SMB
Cable Length: 3.5m
• Specifications subject to change without
notice.
240MHz,
1452
1492MHz
16V

Hide quick links:

Advertisement

loading

  Also See for Kenwood CX-DAB1

  Related Manuals for Kenwood CX-DAB1

  Related Content for Kenwood CX-DAB1