ZyXEL Communications Prestige 100 IH User Manual page 64

ZyXEL
required if Dial-In IP Address Supplied By: Dial-in User is set to 'No'.
You can configure this field even if Dial-in User is set to 'Yes', in which
case the Prestige will accept the IP address if the remote peer specifies
one; otherwise, an IP address is assigned from the pool. The default is
'No'.
11. IP Pool: IP Start Addr - This field is active only if you selected 'Yes'
in the Dial-In IP Address Supplied By: IP Pool field. The IP pool
contains contiguous IP addresses and this field specifies the first one in
the pool.
12. IP Count (1,2) - In this field, enter the number (1 or 2) of the addresses
in the IP Pool. For example, if the starting address is 192.168.135.5 and
the count is 2, then the pool will have 192.68.135.5 and 192.68.135.6
13. Session Options: Input Filter Sets and Session Options: Output
Filter Sets - In these fields, you need to select the filter set(s) to filter the
incoming and outgoing traffic between your Prestige and the Remote
Dial-in User. Please keep in mind that these filter set(s) will only apply to
all Remote Dial-in Users but not the Remote Nodes.
You can choose from 12 different filter sets. In addition, you can link up
to 4 filter sets together for further customization (e.g., '1, 5, 9, 12').
Please note that spaces and ',' are accepted in this field. For more
information on customizing your filter sets, please see Chapter 9 on Filter
Configuration. The default is blank, i.e., no filters.
14. Session Options: Idle Timeout - This value is the number of idle
seconds that elapses before the dial-in user is automatically disconnected.
Idle Timeout is the period of time when there is no data traffic between
the dial-in user or Remote Node and the Prestige. This field will only be
used if the Recv. Authen is set to 'None' and the call is not mapped to
any Remote Node or Remote Dial-in User or the Prestige calls back to
the Remote Dial-in User.
Once you have completed filling in 'Menu 13 - Default Dial-in Setup', press
ENTER at the message: 'Press ENTER to Confirm ...' to save your
selections, or press ESC at any time to cancel your selections.
Page 54
Prestige 100IH User's Guide
Dial-In Configuration