Sensor Wash; Memory; Optimise Standby - Miele G 5585 SCVi Operating Instructions Manual

Settings menu

Sensor wash

You can adjust the Sensor wash
programme so that it will remove
stubborn soiling in a lightly soiled load.
^ Select the setting you want, and
confirm your selection with the
middle button.

Memory

You can use the Memory function to
save the last programme selected.
Instead of the ECO programme, the last
programme selected will be indicated
when the dishwasher is switched off
and back on again at the end of a
programme.
The dishwasher is delivered with the
Memory function deactivated.
^ Select the setting you want, and
confirm your selection with the
middle button.
76

Optimise standby

To save energy, the dishwasher will
switch to Standby mode a few minutes
after the last time a button has been
pressed or a few minutes after the end
of the programme. The display and
indicator lights will go out and only the
K indicator light will flash slowly.
If the dishwasher is not switched off at
the end of the programme, it will switch
off completely after a few minutes in
Standby mode.
The Optimise standby function can be
deactivated if wished. The display and
the indicator lights will not go out, and
the time lapse before the dishwasher
switches off will increase to approx. 6
hours, resulting in higher energy
consumption.
^ Select the setting you want, and
confirm your selection with the
middle button.
The dishwasher will not switch into
Standby mode whilst a programme
is running, if salt or rinse aid needs
to be replenished or there is a fault.
If you only use combination
products containing salt and rinse
aid in your dishwasher, you can
switch the refill indicators off so that
the dishwasher will go into Standby
despite a lack of salt or rinse aid
(see "Before using for the first time").
You cannot switch off fault
indicators.