Table Of Contents; Introduction - Heatrae Sadia Hotflo 10 Fitting Instructions And User Manual

CONTENTS
SECTION
1.0 INTRODUCTION
2.0 TECHNICAL SPECIFICATION
3.0 INSTALLATION
4.0 COMMISSIONING
5.0 EXPLANATION TO USER
6.0 MAINTENANCE
7.0 FAULT FINDING
8.0 SPARE PARTS
9.0 ACCESSORIES
10.0 GUARANTEE
11.0 ENVIRONMENTAL INFORMATION
12.0 SPARES STOCKISTS

1.0 INTRODUCTION

Thank you for purchasing a Heatrae Sadia Hotflo unvented water heater. The
Hotflo water heater is manufactured in the UK to the highest standards and
has been designed to meet all the latest relevant safety specifications.
This Hotflo water heater must be installed, commissioned and maintained by
a competent person only. Please read and understand these instructions prior
to installing your Hotflo unvented water heater. Particular attention should be
paid to the section headed IMPORTANT INSTALLATION POINTS.
Following installation and commissioning, the operation of the heater should
be explained to the user and these instructions left with them for future
reference.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
WARNING: IF WATER FLOWS FROM THE PRESSURE RELIEF VALVE OR
TEMPERATURE/PRESSURE RELIEF VALVE THE ELECTRICITY SUPPLY
MUST BE SWITCHED OFF IMMEDIATELY. CONTACT THE
HEATRAE SADIA SERVICE TEAM (Tel: 0844 8711535) OR AN
APPROVED INSTALLER.
2
PAGE
2
3
4
9
9
10
13
14
14
15
15
16