Normal Playback; Preparing For Playback; Listening To A Source Component - Kenwood KRF-V8030D Instruction Manual

Normal playback

Preparing for playback

16
Some preparatory steps are needed before starting playback.
ON/STANDBY
POWER
SPEAKERS A/B
Selecting the input mode
If you have selected a component connected to the CD, DVD, VIDEO2,
or VIDEO3 jacks, make sure that the input mode setting is correct for the
type of audio signal to be used.
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is "TAPE". To change the
source name associated with the MD/TAPE jacks to "MD," follow the
steps below:
1 Use the INPUT SELECTOR knob to select "MD/TAPE".
2 Hold down the AUTO key for more than 2 seconds.
• The source indication changes to "MD".
• To return to the original indication, repeat the above procedure.
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system to
be used.
A ON : Sound from the speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON : Sound from the speakers connected to the SPEAKERS B
terminals on the rear panel.
A+B ON : Sound from both the speakers connected to the SPEAK-
ERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when listening
with headphones for stereo sound and virtual surround in all
playback modes.
The indicator for the speakers you
want to use should be lit.
SP
CLIP
RDS EON
TP
• Activating a surround mode or selecting "DVD 6ch" as the input
source causes speaker system A to be selected automatically.
• When you use the PRE OUT jacks, press the only SPEAKERS A key
to the on position.
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing POWER or
SYS.POWER (and ON/STANDBY) key(s).
INPUT MODE
AUTO
INPUT SELECTOR
A B TI.VOL
L C R
MUTE
LFE SW
PTY
LS S RS
TA NEWS

Listening to a source component

9
1
Use the INPUT SELECTOR knob, MUSIC key, or MOVIE key
to select the source you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
1 "PHONO"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
6 "VIDEO2"
7 "VIDEO3"
8 "DVD/6ch"
9 "AV AUX"
Selecting a source using the MUSIC key
1 "CD/DVD"
2 "TAPE" or "MD"
3 "TUNER"
4 "PHONO"
Selecting a source using the MOVIE key
1 "VIDEO1"
2 "VIDEO2"
3 "VIDEO3"
4 "DVD/6ch"
5 "AV AUX"
2
Start playback from the selected source.
3
Use the VOLUME CONTROL (VOLUME +/–) to adjust the
volume.
VOLUME CONTROL
INPUT SELECTOR
MUSIC
MOVIE
VOLUME+/–