Setting Up The System; Connecting Audio Components - Kenwood KRF-V8030D Instruction Manual

Setting up the system

Make connections as shown below.
When connecting the related system components, be sure
to also refer to the instruction manuals supplied with the
components you are connecting.
Do not connect the power cord to a wall outlet until all
connections are completed.
DTS disclaimer clause
DTS Digital Surround™ is a discrete 5.1 channel digital audio format
available on CD, LD, and DVD software which consequently cannot be
decoded and played back inside most CD, LD, or DVD players. For this
reason, when DTS-encoded software is played back through the analog
outputs of the CD, LD, or DVD player, excessive noise will be exhibited.
To avoid possible damage to the audio system, proper precautions
should taken by the consumer if the analog outputs are connected
directly to an amplification system. To enjoy DTS Digital Surround™
playback, an external 5.1 channel DTS Digital Surround™ decoder
system must be connected to the digital output (S/P DIF, AES/EBU, or
TosLink) of the CD, LD or DVD player.
This unit is equipped with DTS Digital Surround™ decoder.
Notes
1. Be sure to insert all connection cords securely. If their connections are
imperfect, the sound may not be produced or noise may interfere.
2. Be sure to remove the power cord from the AC outlet before plugging or
unplugging any connection cords. Plugging/unplugging connection cords
without disconnecting the power cord can cause malfunctions and may
damage the unit.
3. Do not connect power cords from components whose power consump-
tion is larger than what is indicated on the AC outlet at the rear of this unit.
Analog connections
Audio connections are made using RCA pin cords. These cables transfer
stereo audio signal in an "analog" form. This means the audio signal
corresponds to the actual audio of two channels. These cables usually have
2 plugs each end, one red for the right channel and one white for the left
channel. These cables are usually packaged with the source unit, or are
available at your local electronics retailer.
Microcomputer malfunction
If operation is not possible or an erroneous display appears, even though
all connections have been made properly, reset the microcomputer
referring to "In case of difficulty".
CAUTION (Except for U.S.A. and Canada)
Be sure to adhere followings. Or proper ventilation will be blocked
causing damage or fire hazard.
• Install the KRF-V8030D on the top of the system.
• Do not place any objects impairing heat radiation onto the top of unit.
• Leave a space around the unit (from the largest outside dimension
including projection) equal or greater than, shown below.
Top panel : 50 cm Side panel : 10 cm
CAUTION (For U.S.A. and Canada)
Be sure to adhere followings. Or proper ventilation will be blocked
causing damage or fire hazard.
• Install the VR-409 on the top of the system.
• Do not place any objects impairing heat radiation onto the top of unit.

Connecting audio components

§
Back panel : 10 cm
When you connect the unit and the CD or MD player with the
digital connection, you can enjoy the higher sound quality.
Shape of AC outlets
U.S.A. and Canada
Australia
Other countries
SYSTEM CONTROL
!
jacks
L
R
GND
REC OUT PLAY IN
PHONO CD/DVD MD/TAPE1
IN
OUT
CD player
OUT
To AC wall outlet
REC OUT PLAY IN
MONITOR
AUDIO
IN OUT
3 head cassette deck or
graphic equalizer *
OUT
MD recorder or
Cassette deck
Record player
9
7