Connecting The Dvd 6-Channel Jacks - Kenwood KRF-V8010D Instruction Manual

Kenwood audio video surround receiver instruction manual

Hide thumbs Also See for KRF-V8010D:

Service manual (33 pages)

Instruction manual (25 pages)

Service manual (33 pages)

Table Of Contents

Table of Contents

Input mode settings

The VIDEO2 and VIDEO3 inputs each include jacks for digital audio

input and analog audio input.

You must select beforehand which type of input is to be used for each

connected component. The initial factory setting is to use the digital

audio signal for playback.

To use the analog audio input for playback instead (if, for example,

you have connected a VCR to the VIDEO2 or VIDEO3 input), you must

set the input mode for the corresponding input to the analog mode.

After completing connections and turning on the receiver, follow the

steps below.

INPUT MODE

1 Use the INPUT SELECTOR knob to select either VIDEO2 or

VIDEO3.

2 Press the INPUT MODE key.

Each press switches the setting as follows:

1 D-AUTO (digital input, auto sound)

2 D-MANUAL (digital input, manual sound)

3 ANALOG (analog input, manual sound)

4 DVD 6ch (this appears in the display only when set)

When DVD 6ch is selected, you cannot use the SPEAKER

B, BASS BOOST, MONITOR, SOURCE DIRECT, LISTEN

MODE, SOUND, and SET UP keys.To use these keys, select

an input mode other than DVD 6ch.

Digital input:

Select this setting to play digital signals from a DVD, CD, or LD

player.

Analog input:

Select this setting to play analog signals from a cassette deck, VCR,

or turntable. Also, select this setting to listen to DVD 2-channel

signal in analog format.

DVD 6ch input:

The 6-channel signal sent from the DVD player is played as is.

Auto sound:

In the auto sound mode (AUTO SOUND indicator lights), the

receiver selects the listening mode automatically during playback

to match the type of input signal (Dolby Digital, PCM, etc.) and the

speaker setting. The initial factory setting is auto sound on.

To keep the receiver set to the currently selected listening mode,

use the INPUT MODE key to select "D-MANUAL" (manual sound).

However, even when this setting is selected, there may be cases in

which the listening mode is selected automatically to match a Dolby

Digital source signal depending on the combination of listening

mode and source signal.

INPUT SELECTOR

DVD 6 channel input mode settings

When connecting a DVD player with 6-channel output jacks be sure

to perform the following settings. Set VIDEO2 for connection to the

COAXIAL jack, or VIDEO3 for connection to the OPTICAL jack of the

DVD player.

Note that when DVD 6ch is selected, you can only set one of either

VIDEO2 or VIDEO3.

MULTI CONTROL

SET UP

1 Press the SET UP key for 2 seconds or more in the stand-by

mode.

2 Use the MULTI CONTROL knob to select either "6ch V2" or

"6ch V3".

3 Press the SET UP key to enter the contents.

• The receiver switches to the stand-by mode 3 seconds after the

settings have been completed.