Listening To A Source Component; Adjusting The Sound - Kenwood KRF-V8010D Instruction Manual

Listening to a source component

16
VIDEO
1
Use the input selector (INPUT SELECTOR (AUDIO, VIDEO))
to select the source you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
1 TUNER
2 "CD" ("CD"*)
3 "TAPE" or "MD" ("TAPE"*)
4 "PHONO"("PHONO"*)
5 "VIDEO1" ("VCR1"*)
6 "VIDEO2" ("VCR2"*)
7 "VIDEO3" ("VCR3"*)
Selecting a source using the AUDIO key on the remote control
1 "CD" ("CD"*)
2 "TAPE" or "MD" ("TAPE"*)
3 TUNER
4 "PHONO"("PHONO"*)
Selecting a source using the VIDEO key on the remote control
1 "VIDEO1" ("VCR1"*)
2 "VIDEO2" ("VCR2"*)
3 "VIDEO3" ("VCR3"*)
4 "<--->" (Not used by this receiver.)
* Once setup codes are registered in the remote control, the input
name display changes according to the name of the registered
component.
Example: if you register a VCR at the VIDEO 1 jacks, "VCR" appears
instead of "VIDEO 1".
• When using the remote control after initial setup, any inputs that
have not been registered with a setup code are deleted from the
cyclic list.
• The INPUT SELECTOR on the front panel of the receiver always
cycles through all inputs.
2
Start playback from the selected source.
3
Use the VOLUME CONTROL (VOLUME) to adjust the
volume.
VOLUME CONTROL
INPUT SELECTOR
AUDIO
VOLUME

Adjusting the sound

BASS BOOST
PHONES
TUNING/SKIP
Adjusting the tone
If a source that is not Dolby Digital is selected, you can adjust the sound
quality when the receiver is in the stereo mode.
1 Press the SOUND key to select the tone mode to be adjusted.
BASS: Select this to adjust the low frequency range.
(Press the SOUND key once.)
TREB: Select this to adjust the high frequency range.
(Press the SOUND key twice.)
SP A
2 Use the MULTI CONTROL (TUNING/SKIP) to adjust the sound
quality.
• The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
• The adjustment item is displayed for approximately eight sec-
onds.
• If you used the remote control to perform the above setting, press
the VIDEO key at this point to turn off the remote control's own
adjustment mode. In this case, the input source is not switched.
RC2
Once-touch low frequency emphasis (bass boost)
If a source that is not Dolby Digital is selected, you can adjust the sound
RC4
quality when the receiver is in the stereo mode.
Press the BASS BOOST key.
• Press the key once to select the maximum (+10) low frequency
emphasis setting.
• This key does not function when the receiver is in the sound quality
or ambience effects adjustment mode.
Switching back to the previous setting
Press the BASS BOOST key again.
SOURCE DIRECT VOLUME CONTROL
SOUND
MULTI CONTROL
SPEAKERS A/B
VIDEO
MUTE
VOLUME
SOUND
T REB +4
Normal playback
KRF-V8010D (En/T)
AUTO
MEMO.
STEREO ST.
TUNED