Table of Contents
Advertisement
E L A N
H O M E
S Y S T E M S
CDs, they do their recording in the evening and let the VIA!dj compress the data overnight
while the VIA!dj is not playing. This only applies to CDs loaded into the VIA!dj's CD tray. This does
not apply to bulk-loading methods. See Section VI, pg. 14-15, Bulk-Loading CDs Into the
VIA!dj.
DTS 5.1 ENCODED CDs
The VIA!dj can record DTS 5.1 encoded audio CDs. These CDs must be recorded uncompressed
and can only be played out of the VIA!dj's digital output, which should be connected to a surround
sound processor.
The VIA!dj cannot record:
• Copy protected CDs
• Non-audio CDs
• CD-ROMs that have not been 'closed'
• HDCD
• CD-i
• SACD
• DVD video or audio
NOTE: To insure 100% audio integrity, recording time may slow down in order to correctly
record the audio information from CDs that may have impurities on them such as finger-
prints, dust, scratches, etc. Also, the VIA!dj uses a great deal of its processing power while
in RECORD mode. You may therefore experience slightly longer delays when accessing
music from the VIA!dj's hard drive while it is recording.
See the VIA!dj User's Guide for step-by-step instructions on recording CDs.
V.
ADVANCED SETTINGS
PROXY SERVER SETTINGS
On the Internet Access menu there is an option called Proxy Server Settings. If the VIA!dj can
not retrieve album information from the Internet, it is possible that the homeowner's ISP uses a dif-
ferent site, or a Proxy Server, to access web sites. If this is the case you will need to contact the
ISP and get the Proxy Server's address. This information, plus the user name and password, must
then be entered in the Proxy Server Settings menu.
CONTROLLER SETTINGS
XiVALink Options
On the System Settings menu there is an option called Controller Settings. It is possible to use
other manufacturer's touch panels to control the VIA!dj by connecting them to the Controller port
on the dj's rear panel. The default Transmission Speed of this port is set at 38,400. A second
Transmission Speed (9600) can be selected by going to Controller Settings>XiVALink
Options>Transmission Speed>
If using another manufacturer's touch panel to control the VIA!dj, the Ethernet Mode must be set
to Manual, and the dj's IP Address must be entered. See Configuring the VIA!dj's Ethernet
Settings, page 8-10, section B, Manual Settings.
Infrared Options
On rare occasions, a VIA!dj IR command may 'clash' with another IR-controlled device, causing
that component to react when a VIA!dj command is issued. Should this occur it is possible to
change the VIA!dj's IR 'Code Bank' in the hope that a different bank will not interfere with other
components. To change the IR Code Bank go to System Settings>Controller Settings>Infrared
Options>Select> Edit and select a different Code Bank. This will not effect VIA!dj operation.
© ELAN Home Systems 2004 • All rights reserved. 09/04
Edit.
INSTALLATION MANUAL
Page 12
Advertisement
Table of Contents
